Zitat
Hovercontrol_412_PE_v1_FSX
Hovercontrol 412 Personal Edition 1.0 FSX
FSX ONLY This installation has been modified to be compatible with Flight Simulator X. Thanks to Chris Gaeth Panther for his additional help in setting it up and with his configuration assistance. The Hovercontrol 412 is a twin turbine helicopter with a variety of systems and avionics simulated in high detail. Includes many high quality paintjobs. Checklist and references are available on the kneeboard F10 key, as well as on your desktop after install. For distribution from Hovercontrol.com only. Licensing fees apply for unauthorized distribution. Read License agreement for details.
Jordan Moore
Windows Program
Zitat
1. Generator Switches will not move at all, not even a little
This is covered in the first section of both the kneeboard checklist and reference guide. Choose one of the saved Hovercontrol flights and start with it. Then change your 412 and/or move to another geographic location if you choose, and save your own flight. If you want to save your own flight from scratch, you must follow the steps listed on the first part of the checklist or reference.
2. Flight dynamics and controls are too sensitive
The real-world 412 is extremely sensitive to pilot control inputs, but is not unstable. This simulation is the same. It is especially sensitive under maximum gross weight conditions. If you would like a break from the sensitive controls, simply reduce the value of your General Realism Slider in flight simulator. This can be found at the menu Aircraft->Realism Settings->General Realism Slider. Try 60% and then experiment from there. For full realism set this slider to 99% (one click away from the right side).
3. Instruments are not on, or attitude indicators are drooping
You will need to follow the checklist when starting this aircraft. You have forgotten to turn on important system switches.
4. All of my electrical systems are not working
You have consumed the entire charge of your battery. This is mostly likely the result of taking to long to investigate other systems or go through the checklist while your battery is on. If you need extra time to familiarize yourself with the location of panels or systems. Visit the overhead-right panel, and turn the battery bus off until you are ready to continue.
5. HSI heading selection increments by 10 degrees
This is covered in the known issues section of the kneeboard Hovercontrol 412 pilot reference. It is an obscure problem caused by the 3rd party autopilot gauge included with the 412. You can work around the problem by using your mouse wheel to adjust the HSI heading/course knobs. This problem will only occur after you have popped-up the panel that contains the autopilot and autohover systems. If you don't use this panel, the problem will not occur.
Also.. (thanks Gizmocat!)
If you have the registered version of FSUIPC, then you can go to the "Technical" tab and tick the box "Fix Control Acceleration" (Bottom Left Hand Side), this will sort out the doors (Shift-E-2) and the "10 degree step" on the HSI problems.
Dieser Beitrag wurde bereits 1 mal editiert, zuletzt von »Glocke« (17. März 2007, 00:07)